Re: [CAD_CAM_EDM_DRO] Varispeed Motor Control

The machine must be set to highor low gear and then turned on. The speed is then changed using a handwheel. I suspect I'd have to put some sort of stepper motor attachment in place of the hand wheel....leaving the hand wheel on also to allow for manual use of the machine too.


-----Original Message-----
From: Darrell <dgehlsen@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Tuesday, October 24, 2000 10:32 AM
Subject: Re: [CAD_CAM_EDM_DRO] Varispeed Motor Control


It would help to know how the motor speed is controlled now.
Darrell

From: "Gordon Robertson" <Smoke@...>

> Does anyone out there have any info on setting up an

existing machine

> which has a Varispeed 3HP motor so the motor speed can be

contolled

> by the PC CAD/CAM programming? BTW....this machine is

operated off 3

> phase thru a phase converter.
>
> Smoke
>

eGroups Sponsor


Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager



[Non-text portions of this message have been removed]