Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
Posted by
Doug Harrison
on 2000-10-25 15:32:52 UTC
I also had the MK lathe software (actually, the college had it). It
supported threading through an encoder input on the optistep board. It ran
great as a demo but so did the mill software. Political problems prevented
it from ever being used.
Doug
supported threading through an encoder input on the optistep board. It ran
great as a demo but so did the mill software. Political problems prevented
it from ever being used.
Doug
>They
> I have a MK Optistep card driving Applied Motion Products 7 amp drivers.
> use a standard step / direction setup. I'm using them on mills so can'tsay
> about threaded....
>
> Peter
> THRD, Inc.
>
Discussion Thread
Bill Darby
2000-10-25 04:14:36 UTC
[CAD_CAM_EDM_DRO] Help choosing software for Gecko drivers.
machines@n...
2000-10-25 06:24:10 UTC
Re: Help choosing software for Gecko drivers.
Bill Darby
2000-10-25 08:03:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
mgrady
2000-10-25 08:07:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
Darrell
2000-10-25 08:51:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
ptengin@a...
2000-10-25 14:13:12 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
Doug Harrison
2000-10-25 15:32:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.