Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
Posted by
ptengin@a...
on 2000-10-25 14:13:12 UTC
In a message dated 10/25/2000 3:25:12 AM Hawaiian Standard Time,
machines@... writes:
<< As Microkinetics only drives it's own controllers that seems to leave
Ahha. >>
I have a MK Optistep card driving Applied Motion Products 7 amp drivers. They
use a standard step / direction setup. I'm using them on mills so can't say
about threaded....
Peter
THRD, Inc.
machines@... writes:
<< As Microkinetics only drives it's own controllers that seems to leave
Ahha. >>
I have a MK Optistep card driving Applied Motion Products 7 amp drivers. They
use a standard step / direction setup. I'm using them on mills so can't say
about threaded....
Peter
THRD, Inc.
Discussion Thread
Bill Darby
2000-10-25 04:14:36 UTC
[CAD_CAM_EDM_DRO] Help choosing software for Gecko drivers.
machines@n...
2000-10-25 06:24:10 UTC
Re: Help choosing software for Gecko drivers.
Bill Darby
2000-10-25 08:03:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
mgrady
2000-10-25 08:07:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
Darrell
2000-10-25 08:51:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
ptengin@a...
2000-10-25 14:13:12 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.
Doug Harrison
2000-10-25 15:32:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help choosing software for Gecko drivers.