Re: [CAD_CAM_EDM_DRO] Re: isolation, current and velocity, encoders

jmw@... wrote:

> Jon,
>
> I see that little Escap on the H&R web page. How do you tune its
> installation so that it delivers the desired (in my case) 7VDC per
> 1000 rpm? By drive pulley sizing, a potentiometer on the output, and
> what if the voltage output is non-linear in RPM?
>
> Thanks.
>
> --Jack

If this is the motor Jon recommended to me months ago then it is pretty linear. I mounted shaft in a collett in the mill where I
have defined speeds and it was rather linear. Much better than I thought it would be.

Dave