Re: [CAD_CAM_EDM_DRO] EMC and Z axis

Wally K wrote:

> I was thinking of getting the X and Y axis working first on my
> bridgeport and doing Z later. Is EMC setup so it can stop and wait
> for manual operation of Z axis, and proceed after the operator hits a
> key.

I ran this way for a while, until I got a 3rd servo amp done. What you
need to do is put an optional stop (M01) in every place where a Z
change is needed. You can also put an operator message on that
line to tell you what Z coordinate is needed. You just hit the S
(resume) key to continue.

Jon