Re: [CAD_CAM_EDM_DRO] BP series 1

I'm interested....I need to find a source to make LOTS of spindles for me.

Smoke
-----Original Message-----
From: Jon Anderson <janders@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Tuesday, December 05, 2000 12:38 PM
Subject: Re: [CAD_CAM_EDM_DRO] BP series 1

>Jon Elson wrote:
>
>> If you can hear it run, listen to the spindle bearings.
>> If they are noisy, you are looking at $700+ for a set of ABEC 7
>> bearings.
>
>There's an outfit in Oregon, C&M Precision Spindle, I think is the name.
>I've gotten a quote of under $400 to do an R8 spindle with what they
>call a quad-pack, four bearings at the taper end. They regrind the taper
>too, .0002 runout max.
>I'm sure they can handle a #30 taper spindle as well.
>If anyone is interested I'll see if I can dig out their brochure.
>
>Jon
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>