Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
Posted by
ptengin@a...
on 2000-12-08 09:26:36 UTC
In a message dated 12/07/2000 3:15:40 PM Hawaiian Standard Time,
jeff@... writes:
<< So, what I'm looking for are some clues about how I would go about
finding this mill. Any ideas? TIA
Jeff >>
Check E-bay. There are many machines, some good many bad, often in CA. The
ones with dead controls go cheap.
You may want to subscribe to several of the used machine newspapers. They
have ads from many of the smaller Mom & Pop type machine dealers. You may
want to simply walk into any machine shop you come across. They often have a
dead or dying mill sitting "out back". I've been offered machines for little
more than scrap value.
Peter
THRD, Inc.
Peter
THRD, Inc.
jeff@... writes:
<< So, what I'm looking for are some clues about how I would go about
finding this mill. Any ideas? TIA
Jeff >>
Check E-bay. There are many machines, some good many bad, often in CA. The
ones with dead controls go cheap.
You may want to subscribe to several of the used machine newspapers. They
have ads from many of the smaller Mom & Pop type machine dealers. You may
want to simply walk into any machine shop you come across. They often have a
dead or dying mill sitting "out back". I've been offered machines for little
more than scrap value.
Peter
THRD, Inc.
Peter
THRD, Inc.
Discussion Thread
Jeff Barlow
2000-12-07 17:13:31 UTC
And now for something completely different.....
Joe Vicars
2000-12-07 17:32:39 UTC
Re: And now for something completely different.....
Jon Anderson
2000-12-07 18:46:49 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
dave engvall
2000-12-07 19:54:13 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
Wally K
2000-12-07 20:03:30 UTC
Re: And now for something completely different.....
mgrady
2000-12-07 20:19:15 UTC
And now for something completely different.....
Jeff Barlow
2000-12-07 20:22:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: And now for something completely different.....
Jeff Barlow
2000-12-07 20:23:53 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
Rab Gordon
2000-12-07 23:00:14 UTC
Re: And now for something completely different.....
ptengin@a...
2000-12-08 09:26:36 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
Smoke
2000-12-08 10:39:13 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
Jon Anderson
2000-12-08 11:40:29 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
Jeff Barlow
2000-12-08 11:59:44 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
Jon Anderson
2000-12-08 13:26:23 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....
ptengin@a...
2000-12-08 23:05:38 UTC
Re: [CAD_CAM_EDM_DRO] And now for something completely different.....