Re: [CAD_CAM_EDM_DRO] Re: Power transformers

Alan, et al,
I will scan my spec sheet for you. Anybody else needing the Triad F204U,
speak up now. The freezing rain may trash the power grid in Atlanta again.
Off list, please.
Rich D.

Alan Marconett KM6VV wrote:

>
> Rich,
>
> Thought that transformer sounded familiar! I have several Triad F-204U
> transformers. Now if I could find more info on the pinout. 8 taps on
> the primary, 2-5 connected, SOLDER on 1 & 6, so that's what was
> previously used. 8-10 and 1-9 connected on secondary, so it was wired
> for 12V. 8 A. Last time I looked, no website for Triad.
>
> Alan KM6VV
>
> "Rich D." wrote:
> >
> > Greg,
> > I'm using the Triad Transformer model F-204. 4A full wave, multi tapped pri/sec.
> > Will go to ~40 DC on the capacitor n/l and lower with tap changes. Great choice.
> > Don't know if still available.
> > Rich D.
> >
> > Greg Nuspel wrote:
> > >
> > > I was wondering where everyone gets their transformers for power supplies. I
> > > can't seem to find 24-30V transformers with sufficient current ratings
> > > locally. Is there a good surplus supplier?
> > >
> > > --Greg Nuspel
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

--
-==Rich=-=Colorado Midland Railway=-=<http://www.geocities.com/cmsteam/>