Re: [CAD_CAM_EDM_DRO] Re: Laptop Computer

Hold the power button in for ten seconds to shut it down in DOS mode, that
will reset it. do a "restart in DOS mode" to get there in the first place.

Cheers, Chris.

* Design engineer, Assembly worker, Cleaner.
* Ohmark Electronics. PO Box 5302, Christchurch, New Zealand.
* http://www.ohmark.co.nz

----- Original Message -----
From: Rich D. <cmsteam@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Thursday, December 14, 2000 3:05 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Laptop Computer


> Ron.
> Not this Toshiba laptop. It reboots to the same mode it was shut down in.
> DOS>off(sleep)>on>DOS.
> Win>off>on>Win (if you catch the menu, you can stop at DOS)exit/win to
windows.
> Dos program>off(sleep)>on>Dos Program.
> Apparently there is only one way to truly shut it down: Quit Windows.
> Am I missing a trick?
> Rich D.
>
> Ron Moore wrote:
> >
> > Rich,
> > When in DOS mode, there is no need to "Shut Down" the operating
> > system. Once you're at a DOS prompt (C:\) just turn the unit off with
> > the power switch. It will load Win9x on the next bootup sequence.
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>