Which is best?
Posted by
Greg Nuspel
on 2000-12-19 04:50:35 UTC
I have two different stepper motors to use on my project and I'm not sure
which is the best one. I have no data sheets but this is the information I
do have.
Motor 1:
Astrosyn 23LM-K005-P3
8 Wire
7.0V ?A
Motor 2:
Japan Servo KP6M2-020
6 Wire
1.7V 3.4A
If anyone knows something about these please let me know. Both types may be
no good for all I know. I want to drive them with a 24V bipolar driver.
There is not a high torque requirement, they are basically used for
positioning in the application I have planned.
-- Greg Nuspel
"Imagination is more important than knowledge."
--Albert Einstein
Clubs Page http://www.cadvision.com/crcss
which is the best one. I have no data sheets but this is the information I
do have.
Motor 1:
Astrosyn 23LM-K005-P3
8 Wire
7.0V ?A
Motor 2:
Japan Servo KP6M2-020
6 Wire
1.7V 3.4A
If anyone knows something about these please let me know. Both types may be
no good for all I know. I want to drive them with a 24V bipolar driver.
There is not a high torque requirement, they are basically used for
positioning in the application I have planned.
-- Greg Nuspel
"Imagination is more important than knowledge."
--Albert Einstein
Clubs Page http://www.cadvision.com/crcss
Discussion Thread
Greg Nuspel
2000-12-19 04:50:35 UTC
Which is best?
Tim Goldstein
2000-12-19 06:32:04 UTC
RE: [CAD_CAM_EDM_DRO] Which is best?
Jon Elson
2000-12-19 12:51:09 UTC
Re: [CAD_CAM_EDM_DRO] Which is best?
James Owens
2000-12-19 15:34:48 UTC
Re: [CAD_CAM_EDM_DRO] Which is best?
JanRwl@A...
2000-12-19 19:39:55 UTC
Re: [CAD_CAM_EDM_DRO] Which is best?