Re: [CAD_CAM_EDM_DRO] Great Dane Power

Magnus, my old mastiff did that to my ex by himself on his first close encounter with a locomotive.
Jesse

Jon Elson wrote:

> Terry Ackland wrote:
>
> > Hi,
> > several years ago our pair of Great Danes dragged the wife on her
> > stomach through a snow bank and across the road and through another
> > snow bank and halfway up a front yard chasing a cat!
> > I would imagine that 2 Danes would equal 1/2 horse? yet I can stop my
> > lathe with one hand, go figure.
> > I guess the dogs could not have dragged the wife around for 8 hours
> > though....mush, mush.
>
> One human, working hard, can easily produce one Hp for a couple of
> minutes. That's why one HP is no problem for a horse to put out all day.
> I certainly can't stop MY lathe or mill on any speed with my hand! I had
> a Bridgeport M head with 1/2 Hp motor, running on a "phase converter".
> I COULD stop that on the higher speeds, but that motor just DIDN'T like
> running on single phase power!
>
> Jon
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager