Re: [CAD_CAM_EDM_DRO] Current limit for G320's and Dans servo motors?

Never got the email asking the question. The stall current is 20 amps but I
have set all of my G320 amps at 10 amps.
Dan
-----Original Message-----
From: Donald Brock <don.pat.brock@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Wednesday, January 03, 2001 4:27 PM
Subject: [CAD_CAM_EDM_DRO] Current limit for G320's and Dans servo motors?

>Has any one using this combination determined where the current limit
>should be set? I have been unable to get a response from Dan on this
>question.
>
>An e-mail from Mariss Follows.
>
>---------------
>Donald,
>
>Good evening! You can use a 36VDC power supply with a 24VDC motor
>provided you don't over-current the motor. Find out what the motor's
>rated stall current is. Set the current limit on the G320 to that
>value and you will have no problems.
>
>Mariss
>---------------
>
>
>Thanks in advance,
>
>Donald Brock
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>