CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] re: disassembling steppers was Re: re:Re: My CNC Project

Posted by Dan Mauch
on 2001-01-07 10:15:53 UTC
Amen!
Dan
-----Original Message-----
From: ballendo@... <ballendo@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Sunday, January 07, 2001 1:33 AM
Subject: [CAD_CAM_EDM_DRO] re: disassembling steppers was Re: re:Re: My CNC
Project


>Rich,
>
>You MAY be lucky! I hope so! But I want to again Warn the list.
>Taking apart a stepper motor is not generally a good idea. In
>addition to the possibility of ruining, or drastically reducing
>torque output of the stepper, there is the issue of thermal
>expansion. Steppers get hot! If you have taken out the ability to
>deal with this, you may have intermittant, hard to trace problems.
>
>Hope this helps.
>
>Ballendo
>
>P.S. Nothing personal is intended, or implied. You did say you were
>new to this...
>
>'******************************************************************
>Only the endcaps were slipped off. I did not slide out the rotor. The
>bearings are large ball (1/4" id) with a wave spring washer to force
>the rotor to one end and put on a side load. I added
>2 thin washers to almost close up the wave washer. Before, it was
>very easy to shove the shaft into the motor. All very clean. As long
>as the coupling will stay put, there's no reason why 2 perfectly good
>motor bearings shouldn't do the job. Rich D.
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>

Discussion Thread

ballendo@y... 2001-01-07 01:34:37 UTC re: disassembling steppers was Re: re:Re: My CNC Project Dan Mauch 2001-01-07 10:15:53 UTC Re: [CAD_CAM_EDM_DRO] re: disassembling steppers was Re: re:Re: My CNC Project Mariss Freimanis 2001-01-07 12:09:08 UTC disassembling steppers was Re: re:Re: My CNC Project Smoke 2001-01-07 14:36:45 UTC Re: [CAD_CAM_EDM_DRO] re: disassembling steppers was Re: re:Re: My CNC Project