Re: [CAD_CAM_EDM_DRO] Heidenhein problem
Posted by
Jon Elson
on 2001-01-10 15:17:42 UTC
Graeme Murray wrote:
died. Possibly, there is a bad connection from the servo amp to the motor.
What is happening is the control sends a command to the servo amp, expects
the motor to start moving the axis, but there is no motion detected from the
encoder. Check for blown fuses, etc. in the servo amps.
Jon
> Hi ,Sounds like the Z axis servo amp is dead, the belt broke, or the motor has
> I am writing to try and help a friend who has a problem with an old model
> Heidenhein TNC155 controller .
> It is a with the Z axis and states
> " Gross position error " before passing the reference marks .There is no
> response from the Z axis.
died. Possibly, there is a bad connection from the servo amp to the motor.
What is happening is the control sends a command to the servo amp, expects
the motor to start moving the axis, but there is no motion detected from the
encoder. Check for blown fuses, etc. in the servo amps.
Jon
Discussion Thread
Graeme Murray
2001-01-10 14:25:48 UTC
Heidenhein problem
Jon Elson
2001-01-10 15:17:42 UTC
Re: [CAD_CAM_EDM_DRO] Heidenhein problem
Paul
2001-01-10 15:27:44 UTC
Re: [CAD_CAM_EDM_DRO] Heidenhein problem
Ozzie@h...
2001-01-10 19:39:09 UTC
Re: Heidenhein problem