Re: [CAD_CAM_EDM_DRO] wire cutting edm

Rich;
that is exactly what I have in mind
It should not be too difficult to build although the electronics shall be a bit harder
regards
mariano


"Rich D." wrote:

> diazden,
> The very thing I have my brain cooking up!
> At least a 2 axis unit, at first. From what I understand this would be a X - Y
> table setup (2 pairs of slide way rods, crossed to leave a thru pocket for the wire
> and cutting area) and wire feed/takeup reels with EDM electronics. The controller
> will have a current sense input to pause on contact-wait-procede scheme.
> The voltage/current contol will have to be a little more refined than the usual
> Plunge EDM units. Does this sound pretty much "on rack"?
> Rich D.
>
> diazden wrote:
> >
> > now there is another subject
> > has anyone on this list made a successful cnc edm wire cutter?
> > regards
> > mariano who still is playing around with digitizers
> -
> -==Rich=-=Colorado Midland Railway=-=<http://www.geocities.com/cmsteam/>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager