Re: [CAD_CAM_EDM_DRO] Correl to cutting
Posted by
wanliker@a...
on 2001-01-16 00:42:55 UTC
In a message dated 1/10/01 3:50:14 PM Mountain Standard Time, KM6VV@...
writes:
<<
I definitely SECOND Tim's recommendation of Vector CAD/CAM. Good
support from Fred, and the Vector Forum! Runs Great!
software and license to get it going again. I hope there is good
documentation for doing the 3 D stuff, there was nothing in the demo.
I assume that a lot of the drawing will have to be 3D is there are three axis
to mill.
Any hints and kinks you want to send to me, or post on the list, better,
would be greatly appreciated. Have you worked with the CNCPRO program at all?
bill
writes:
<<
I definitely SECOND Tim's recommendation of Vector CAD/CAM. Good
support from Fred, and the Vector Forum! Runs Great!
>>I have used the demo to make a few drawings, and am not waiting for the
software and license to get it going again. I hope there is good
documentation for doing the 3 D stuff, there was nothing in the demo.
I assume that a lot of the drawing will have to be 3D is there are three axis
to mill.
Any hints and kinks you want to send to me, or post on the list, better,
would be greatly appreciated. Have you worked with the CNCPRO program at all?
bill
Discussion Thread
Dan Eldredge
2001-01-10 08:01:55 UTC
Correl to cutting
Tim Goldstein
2001-01-10 08:39:39 UTC
RE: [CAD_CAM_EDM_DRO] Correl to cutting
Tom Eldredge
2001-01-10 10:17:20 UTC
Re: [CAD_CAM_EDM_DRO] Correl to cutting
Alan Marconett KM6VV
2001-01-10 11:33:22 UTC
Re: [CAD_CAM_EDM_DRO] Correl to cutting
Tim Goldstein
2001-01-10 12:50:47 UTC
RE: [CAD_CAM_EDM_DRO] Correl to cutting
Alan Marconett KM6VV
2001-01-10 14:47:50 UTC
Re: [CAD_CAM_EDM_DRO] Correl to cutting
wanliker@a...
2001-01-16 00:42:55 UTC
Re: [CAD_CAM_EDM_DRO] Correl to cutting