Re: [CAD_CAM_EDM_DRO] Pclathe / Pcmill program
Posted by
Wayne Weedon
on 2001-01-20 14:53:41 UTC
In article <94a3o4+aal0@...>, niglyn@...
writes
Hi
designer has gone a different route to what most people into CNC's
expect.
The machine is programmed by drawing the part in the integrated drawing
package, that is it!
I think most CNC people would expect an industry standard programming
scheme ie G Codes. I expect it works very well, but personally it
would not be for me.
Strangely it was 1st developed for turning, and even at this point it
does not support spindle encoders, so cannot screwcut.
Regards
Wayne....
--
---------------------------------------------------------------------------
Wayne M Weedon Email: wayne@...
Fdos Design Poole UK
Tel +44-1202-677025
Fax +44-1202-770515
Specialists in small batch & Production Mechanical/Electrical Engineering
---------------------------------------------------------------------------
writes
Hi
>anybody know anything about PClathe made by HSE pcdrech?I have seen this at the last two ME shows. It works well, but the
>
>I saw a demo on a warbeco machine and ordered one at the model
>engineering show1 It arrives soon!! (better tell the wife)
>
>Always being one to save time I am on the lookout for good pre
>written drawings so I can play with it as soon as it arrives.
designer has gone a different route to what most people into CNC's
expect.
The machine is programmed by drawing the part in the integrated drawing
package, that is it!
I think most CNC people would expect an industry standard programming
scheme ie G Codes. I expect it works very well, but personally it
would not be for me.
Strangely it was 1st developed for turning, and even at this point it
does not support spindle encoders, so cannot screwcut.
Regards
Wayne....
--
---------------------------------------------------------------------------
Wayne M Weedon Email: wayne@...
Fdos Design Poole UK
Tel +44-1202-677025
Fax +44-1202-770515
Specialists in small batch & Production Mechanical/Electrical Engineering
---------------------------------------------------------------------------
Discussion Thread
niglyn@b...
2001-01-19 11:25:22 UTC
Pclathe / Pcmill program
Wayne Weedon
2001-01-20 14:53:41 UTC
Re: [CAD_CAM_EDM_DRO] Pclathe / Pcmill program