Re: [CAD_CAM_EDM_DRO] Getting started
Posted by
Smoke
on 2001-01-22 20:52:13 UTC
ASctuyally there is one other. It's done via very high pressure liquid, but
I don't think it's a good one for any home shop machinist to be attempting
to use.
Smoke
I don't think it's a good one for any home shop machinist to be attempting
to use.
Smoke
>The only other "clean" cutting in metal that I know of is by plasmacutting.
>
>Jeff
>
>
Discussion Thread
Simon
2001-01-21 23:25:21 UTC
Getting started
Tim Goldstein
2001-01-22 07:11:49 UTC
RE: [CAD_CAM_EDM_DRO] Getting started
zeff1015@a...
2001-01-22 15:39:19 UTC
Re: [CAD_CAM_EDM_DRO] Getting started
Hans Vogel
2001-01-22 17:18:01 UTC
Re: [CAD_CAM_EDM_DRO] Getting started
dave engvall
2001-01-22 18:24:29 UTC
Re: [CAD_CAM_EDM_DRO] Getting started
Hans Vogel
2001-01-22 19:58:06 UTC
Re: [CAD_CAM_EDM_DRO] Getting started
Smoke
2001-01-22 20:52:13 UTC
Re: [CAD_CAM_EDM_DRO] Getting started
galt1x
2002-05-13 22:56:05 UTC
Getting started
Greg Pettengill
2002-05-14 06:10:17 UTC
Re: [CAD_CAM_EDM_DRO] Getting started
Tim Goldstein
2002-05-14 06:32:59 UTC
Re: [CAD_CAM_EDM_DRO] Getting started
stephen_stallings
2002-05-14 08:14:21 UTC
Re: Getting started - MaxNC comments
tonyjeffree
2002-05-14 09:32:11 UTC
Re: Getting started - MaxNC comments
Alan Marconett KM6VV
2002-05-14 10:40:30 UTC
Re: [CAD_CAM_EDM_DRO] Getting started
jeffdavis516
2002-05-14 12:56:22 UTC
Re: Getting started