RE: [CAD_CAM_EDM_DRO] Why did I get this message after posting to this forum?
Posted by
Tim Goldstein
on 2001-01-23 08:14:50 UTC
I tried looking through the log of subscriptions for the last few weeks
since this started and I don't see any addresses added that are
@.... It would seem that someone subscribed and put in a bad
address, but the list software does not pick it up as a bounce and the
intended recipients ISP sends us this message. I will try to contact
e-groups and see if I can find anything out.
Tim
[Denver, CO]
since this started and I don't see any addresses added that are
@.... It would seem that someone subscribed and put in a bad
address, but the list software does not pick it up as a bounce and the
intended recipients ISP sends us this message. I will try to contact
e-groups and see if I can find anything out.
Tim
[Denver, CO]
> I just replied to Carlos's message on finishing ends of ball screws,
> this message came back at the same time as my post to the group.
> I opened both his post and my response, while viewing full
> headers, and
> there's no reference to an Aldelphia.com anywhere.
> Strange.
>
> Jon
> FAQ: http://www.ktmarketing.com/faq.html
Discussion Thread
Jerry Kimberlin
2001-01-22 20:18:14 UTC
Re: [CAD_CAM_EDM_DRO] Why did I get this message after posting to this forum?
dave engvall
2001-01-22 21:39:35 UTC
Re: [CAD_CAM_EDM_DRO] Why did I get this message after posting to this forum?
Brian Pitt
2001-01-23 00:19:14 UTC
Re: [CAD_CAM_EDM_DRO] Why did I get this message after posting to this forum?
Jon Anderson
2001-01-23 07:49:47 UTC
Re: [CAD_CAM_EDM_DRO] Why did I get this message after posting to this forum?
Tim Goldstein
2001-01-23 08:14:50 UTC
RE: [CAD_CAM_EDM_DRO] Why did I get this message after posting to this forum?
Smoke
2001-01-23 10:33:14 UTC
Re: [CAD_CAM_EDM_DRO] Why did I get this message after posting to this forum?