Re: [CAD_CAM_EDM_DRO] Why did I get this message after posting to this forum?

I just happen to get cable Service from Adelphia. I don't know where
Adelphia's home base is but I do know they bought out the local cable
company. I think I'll run over there tomorrow while I'm in town and see if
they can tell me why this message is being sent to everyone.

Smoke


-----Original Message-----
From: Jon Anderson <janders@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Tuesday, January 23, 2001 9:42 AM
Subject: Re: [CAD_CAM_EDM_DRO] Why did I get this message after posting to
this forum?

>I just replied to Carlos's message on finishing ends of ball screws,
>this message came back at the same time as my post to the group.
>I opened both his post and my response, while viewing full headers, and
>there's no reference to an Aldelphia.com anywhere.
>Strange.
>
>Jon
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>FAQ: http://www.ktmarketing.com/faq.html
>
>