CAD CAM EDM DRO - Yahoo Group Archive

RE: GT vs. HTD belts

on 2001-01-25 05:41:21 UTC
Ballendo -

Stock Drive Products lists GT belts in 2, 3, and 5mm pitch. York
Ind. Only lists 2 and 3mm pitch.

Carlos Guillermo
VERVE Engineering & Design

-----Original Message-----
From: ballendo@... [mailto:ballendo@...]
Sent: Thursday, January 25, 2001 8:22 AM
To: CAD_CAM_EDM_DRO@egroups.com
Subject: [CAD_CAM_EDM_DRO] re:RE: Subject: GT vs. HTD belts

Gary,

Thank you for the info. That's pretty much what I've read on
the 'advertorial' websites I've looked at... Good to know it's not
just marketing BS...

Are they available in 3mm and 5mm pitch?

Ballendo

P.S. It's interesting that Gates HTD 'version' belt was already a
step towards this many years ago.... (they "cut out" the middle of
the bottom of the parabola as early as 1991, AFAIK)

Discussion Thread

Rose, Gary 2001-01-24 06:10:20 UTC RE: Subject: GT vs. HTD belts ballendo@y... 2001-01-25 05:22:07 UTC re:RE: Subject: GT vs. HTD belts Carlos Guillermo 2001-01-25 05:41:21 UTC RE: GT vs. HTD belts