re:Re: re: IJK interp
Posted by
ballendo@y...
on 2001-01-26 03:16:59 UTC
Jon,
This was my point! And most commercial controls only allow (or
recommend) the R word for arcs of less than 180 degrees...
Ballendo
This was my point! And most commercial controls only allow (or
recommend) the R word for arcs of less than 180 degrees...
Ballendo
>Where can't be calculated, because there is no distance between the
>start and end. The start and end have to be different for the
>center to be calculated.<snip>
>Jon
Discussion Thread
Alan Marconett KM6VV
2001-01-25 19:17:46 UTC
re: IJK interp
ballendo@y...
2001-01-25 21:32:33 UTC
re:Re: re:Re: re: IJK interp
Jon Elson
2001-01-25 22:51:18 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: re: IJK interp
Smoke
2001-01-25 23:38:30 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: re:Re: re: IJK interp
ballendo@y...
2001-01-26 03:16:59 UTC
re:Re: re: IJK interp
ballendo@y...
2001-01-26 03:34:59 UTC
re:Re: re:Re: re: IJK interp
Smoke
2001-01-26 09:52:12 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: re:Re: re: IJK interp