re:1/4" R8 endmill holders found as per req

Jon,

More likely, this is an endmill holder with a 1/4 bore, and a
setscrew to lock on the 'flat' of the endmill.

Hope this helps.

Ballendo

P.S. If it is a collet system, the low price would scare me off it!

>>STAN MCDONALD wrote:
>> You must use a R8 collet holder for the ¼'' . #69-510-016 @ $5.99
>>US Funds
>> are in stock.. phone 18004451445 and ask for wanda.
>> This is for all the people asking about r8 end mill holders.

>I think this was started by me. Could you give me some more
>info on this item? I'm guessing this is an R-8 arbor that holds a
>collet. Is this only for 1/4" collets, or does the arbor/holder take
>a range of sizes? What is the collet style? And, what is the part
>number and price of the collet? (I can't imagine at $5.99 that the
>collet is included at that price.)
>Thank, Jon