CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] re:Cnc router help

Posted by Doug Harrison
on 2001-01-30 14:41:49 UTC
----- Original Message -----
From: <ballendo@...>

> So the long Z axis is "not used" most of the time? It just 'sticks
> up' in the air (adding moment load on EVERY move). And when yopu need
> it you "prop up" the gantry cars?
>
> Ballendo

That's basically correct. It's just like putting a riser block on a
Bridgeport. The moment loads will probably cancel out, as most of the
inertial mass (spindle) is at the bottom of the Z slide anyway.

Doug

Discussion Thread

smv@b... 2001-01-27 09:18:07 UTC Cnc router help Les Watts 2001-01-27 10:47:39 UTC Re: [CAD_CAM_EDM_DRO] Cnc router help Doug Harrison 2001-01-27 17:49:12 UTC Re: [CAD_CAM_EDM_DRO] Cnc router help ballendo@y... 2001-01-29 13:57:00 UTC re:Cnc router help ballendo@y... 2001-01-29 15:04:20 UTC re:Cnc router help Smoke 2001-01-29 15:50:45 UTC Re: [CAD_CAM_EDM_DRO] re:Cnc router help Doug Harrison 2001-01-29 17:07:04 UTC Re: [CAD_CAM_EDM_DRO] re:Cnc router help ballendo@y... 2001-01-29 20:32:07 UTC re:re:Cnc router help ballendo@y... 2001-01-29 20:44:04 UTC re:Cnc router help Smoke 2001-01-29 20:54:54 UTC Re: [CAD_CAM_EDM_DRO] re:re:Cnc router help Les Watts 2001-01-30 06:10:45 UTC Re: [CAD_CAM_EDM_DRO] re:Cnc router help Doug Harrison 2001-01-30 14:41:49 UTC Re: [CAD_CAM_EDM_DRO] re:Cnc router help