CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Another silly newbie question

on 2001-02-04 11:40:23 UTC
Hello.
I am curious as to what a ball screw is. I have looked up and found pictures
but they are never clear enough for me to make out what is going on.
I have heard reference to them on the Sherline group.
What are they and what do they do?
Arnold

-----Original Message-----
From: The Sheppard Residence [mailto:peter@...]
Sent: Sunday, February 04, 2001 10:49 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Another silly newbie question

I appreciate the use of a ball screw to reduce backlash, do I assume this
totally replaces any existing thread (acme etc.) present on the
table/quill?

Cheers

Peter


Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager

FAQ: http://www.ktmarketing.com/faq.html

Discussion Thread

The Sheppard Residence 2001-02-04 10:47:31 UTC Another silly newbie question Arnold &Diane Chord 2001-02-04 11:40:23 UTC RE: [CAD_CAM_EDM_DRO] Another silly newbie question Tim Goldstein 2001-02-04 11:53:23 UTC RE: [CAD_CAM_EDM_DRO] Another silly newbie question Jon Elson 2001-02-04 22:42:17 UTC Re: [CAD_CAM_EDM_DRO] Another silly newbie question