Re: [CAD_CAM_EDM_DRO] Building a CNC Router
Posted by
Joe Vicars
on 2001-02-09 05:17:08 UTC
Check out the "files" section from the list main page. This contains many links to member's work.
So far as I know there is not a website that describes "how to" in detail from start to finish.
But many of them will give you most of what you need to know.
Also go to www.metalworking.com and find the tutorial "Jones on stepping motors". Read that for a couple of weeks till it sinks in.
I kept a copy on the potty for about six months.
fuddham@... wrote:
So far as I know there is not a website that describes "how to" in detail from start to finish.
But many of them will give you most of what you need to know.
Also go to www.metalworking.com and find the tutorial "Jones on stepping motors". Read that for a couple of weeks till it sinks in.
I kept a copy on the potty for about six months.
fuddham@... wrote:
> I am not new to woodworking or metalworking, but have very little
> experence with CNC. I want to build a CNC router. Is there a site
> that will guide you through step-by-step in the process?
>
> Thanks
>
> Fudd
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
Discussion Thread
fuddham@a...
2001-02-08 18:36:51 UTC
Building a CNC Router
Joe Vicars
2001-02-09 05:17:08 UTC
Re: [CAD_CAM_EDM_DRO] Building a CNC Router
Doug Fortune
2001-02-09 07:33:08 UTC
[CAD_CAM_EDM_DRO] Building a CNC Router
skauphusma@a...
2001-02-09 07:34:02 UTC
Re: Building a CNC Router
Doug Harrison
2001-02-09 16:46:09 UTC
Re: [CAD_CAM_EDM_DRO] Building a CNC Router
wbhinkle@a...
2001-02-09 16:54:12 UTC
Re: [CAD_CAM_EDM_DRO] Building a CNC Router