[CAD_CAM_EDM_DRO] Building a CNC Router
Posted by
Doug Fortune
on 2001-02-09 07:33:08 UTC
Joe Vicars wrote:
the nitty gritty:
http://www.cuug.ab.ca/~fortuned/cncKITS_faq.html
> Check out the "files" section from the list main page. This contains many links to member's work.Also, you can read this for a sweeping overview before you get into
> So far as I know there is not a website that describes "how to" in detail from start to finish.
> But many of them will give you most of what you need to know.
> Also go to www.metalworking.com and find the tutorial "Jones on stepping motors". Read that for a couple of weeks till it sinks in.
the nitty gritty:
http://www.cuug.ab.ca/~fortuned/cncKITS_faq.html
Discussion Thread
fuddham@a...
2001-02-08 18:36:51 UTC
Building a CNC Router
Joe Vicars
2001-02-09 05:17:08 UTC
Re: [CAD_CAM_EDM_DRO] Building a CNC Router
Doug Fortune
2001-02-09 07:33:08 UTC
[CAD_CAM_EDM_DRO] Building a CNC Router
skauphusma@a...
2001-02-09 07:34:02 UTC
Re: Building a CNC Router
Doug Harrison
2001-02-09 16:46:09 UTC
Re: [CAD_CAM_EDM_DRO] Building a CNC Router
wbhinkle@a...
2001-02-09 16:54:12 UTC
Re: [CAD_CAM_EDM_DRO] Building a CNC Router