RE: Stepper Driver power supply

Wow I probably have this stuff in my shop already. Is this set up clean
enough to power the board?
JR

-----Original Message-----
From: Tim Goldstein [mailto:timg@...]
Sent: Friday, August 06, 1999 1:09 PM
To: CAD_CAM_EDM_DRO@onelist.com
Subject: Re: [CAD_CAM_EDM_DRO] Stepper Driver power supply


From: "Tim Goldstein" <timg@...>

Dan has the following items listed on his web page:

A 110VAC to 24VAC 10 amp transformer ($40)
A 15000UF 50VDC computer grade Cap $12
a Bridge rectifier 400V PIV 20 amps $5

If you wire them together with an appropriate switch and fuse you will have
a ~36 VDC power supply that will work perfectly for you.

Tim
[Denver, CO]

----- Original Message -----
From: John Ross <johnr@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Friday, August 06, 1999 12:32 PM
Subject: RE: [CAD_CAM_EDM_DRO] Quiet list


> From: John Ross <johnr@...>
>
> Building one of Dan's 5 amp kits. :-). Anyone have a suggestion for a
power
> supply?
> JR




--------------------------- ONElist Sponsor ----------------------------

ONElist: home to the world's liveliest email communities.

------------------------------------------------------------------------
Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
bill,
List Manager