RE: [CAD_CAM_EDM_DRO] Gate timing belts
Posted by
Carlos Guillermo
on 2001-02-19 10:48:34 UTC
Les -
I can't seem to find "GT2" belts. I am only aware of the GT type. What's
the difference?
Thanks,
Carlos Guillermo
VERVE Engineering & Design
-----Original Message-----
From: Les Watts [mailto:leswatts@...]
Sent: Monday, February 19, 2001 12:18 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Gate timing belts
snipped:
The belt size seems small for that much torque but that
is what I get from the figures. They now have GT2 3mm
in 15 mm width but no figures. It would seem that I would
get no better jump torque but have much higher bearing
loads so I will stay with the 9mm.
I can't seem to find "GT2" belts. I am only aware of the GT type. What's
the difference?
Thanks,
Carlos Guillermo
VERVE Engineering & Design
-----Original Message-----
From: Les Watts [mailto:leswatts@...]
Sent: Monday, February 19, 2001 12:18 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Gate timing belts
snipped:
The belt size seems small for that much torque but that
is what I get from the figures. They now have GT2 3mm
in 15 mm width but no figures. It would seem that I would
get no better jump torque but have much higher bearing
loads so I will stay with the 9mm.
Discussion Thread
Les Watts
2001-02-19 09:11:04 UTC
[CAD_CAM_EDM_DRO] Gate timing belts
Carlos Guillermo
2001-02-19 10:48:34 UTC
RE: [CAD_CAM_EDM_DRO] Gate timing belts