CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Interplotation?

on 2001-02-19 11:43:15 UTC
Hi Paul,

I live on Merseyside in the North of the UK. I may be down in London
this week however.

Best wishes,
John

----- Original Message -----
From: "Paul" <Paul.Corner@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, February 19, 2001 7:07 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Interplotation?


>
> John
>
> It sounds as if you would benefit from a one to one session in a CNC
workshop.
> There is much to learn, but the basic concepts are easy to grasp -
Especially
> when you can see the machines in action.
>
> If you are south of the Wash, drop me a note off line.
>
> Regards, Paul.
>
>
> On Mon, 19 Feb 2001, e.heritage@... wrote:
> > Ballendo,
> >
> > Thanks for the descriptions of interpolation. They do indeed sell
> > ech-o-sketches here. You said in the very beginning of your reply that
if I
> > was to imagine a machine with just the X and Z axis then turning one of
> > these knobs would move the pen in four directions. Wouldn't it be
turning
> > both the knobs at the same time? Turning just one will only move it
along
> > one plane so it would only have two directions.
> > I have absolutely no idea what parabolic interpolation is all about
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
>

Discussion Thread

e.heritage@b... 2001-02-18 05:50:16 UTC Interplotation? Alan Marconett KM6VV 2001-02-18 15:50:14 UTC Re: [CAD_CAM_EDM_DRO] Interplotation? ballendo@y... 2001-02-18 18:37:23 UTC Re: Interplotation? e.heritage@b... 2001-02-19 04:01:12 UTC Re: [CAD_CAM_EDM_DRO] Re: Interplotation? Paul 2001-02-19 11:30:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Interplotation? e.heritage@b... 2001-02-19 11:43:15 UTC Re: [CAD_CAM_EDM_DRO] Re: Interplotation? ballendo@y... 2001-02-20 20:30:05 UTC Re: Interplotation?