Re: [CAD_CAM_EDM_DRO] DRO: Newbie Q

Thanks Tim!

Mike
[Columbus, Ohio]

----- Original Message -----
From: "Tim Goldstein" <timg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, February 21, 2001 1:32 PM
Subject: RE: [CAD_CAM_EDM_DRO] DRO: Newbie Q


> http://www.seanet.com/~dmauch/
>
> You will find it about 1/2 way down on the products page. The owner of
> Camtronics is Dan Mauch. He is active on this list and is the person who
> suggested you look at the USDigital encoder strips. There is a picture of
> the 4 axis kit on my website at http://206.19.206.56/dro_kit.htm The two
> axis looks the same, but has a few less connectors and 1 less LS7266R1
chip.
> Board is the same so you can upgrade to 4 axis at any time.
>
> Tim
> [Denver, CO]
>
> > Tim:
> > Where can I purchase this card?
> >
> > Mike
> >
> > FAQ: http://www.ktmarketing.com/faq.html
> >
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>