Stepper motor mounting
Posted by
baileys@k...
on 2001-02-26 13:34:34 UTC
Hello Listee's
I am mounting size 23 stepper motors on my lathe. I plan to drive the
leadscrew
with a 2 to 1 stepdown via timing belts. What I am searching for is a
0.250" mounting plate spacer, this will give me room for the driving pulley
hub. I can make one but
if there is a source of ready made mounting plates available I will go for
that.
Thanks,
Bob B.
I am mounting size 23 stepper motors on my lathe. I plan to drive the
leadscrew
with a 2 to 1 stepdown via timing belts. What I am searching for is a
0.250" mounting plate spacer, this will give me room for the driving pulley
hub. I can make one but
if there is a source of ready made mounting plates available I will go for
that.
Thanks,
Bob B.