Re: FS: UK only Long ball screw
Posted by
John Stevenson
on 2001-03-01 17:08:45 UTC
--- In CAD_CAM_EDM_DRO@e..., carlcnc@s... wrote:
cutting tolerance of 0.1mm [ 0.0039" ]
These are not normal of the shelf rack and pinions but very, very
expensive Swiss ground racks. They run in pairs either side the
gantry with twin servo motors linked by drive shafts to run these so
there is no crabbing.
Upshot of this is the cutting speeds have been increased from a
previous maximun of 3 metres per min [ 120 ipm ] to 10 metres per
min, [400 ipm ]on the thinner stainless and titanium alloys.
>We are getting positional accuracy of 0.02mm [ 0.00078" ]and a
> >" Removed from a laser cutter when we changed over to rack and
> pinion."
>
> John
> how accurate do you expect with rack and pinion?
cutting tolerance of 0.1mm [ 0.0039" ]
These are not normal of the shelf rack and pinions but very, very
expensive Swiss ground racks. They run in pairs either side the
gantry with twin servo motors linked by drive shafts to run these so
there is no crabbing.
Upshot of this is the cutting speeds have been increased from a
previous maximun of 3 metres per min [ 120 ipm ] to 10 metres per
min, [400 ipm ]on the thinner stainless and titanium alloys.
>
> CB
> >
> > machines at ntlworld dot com
Discussion Thread
John Stevenson
2001-03-01 16:17:14 UTC
FS: UK only Long ball screw
carlcnc@s...
2001-03-01 16:35:28 UTC
Re: FS: UK only Long ball screw
John Stevenson
2001-03-01 17:08:45 UTC
Re: FS: UK only Long ball screw