Re: Thread milling!!

I have made a tool up for thread milling either internal or external
threads. This uses one of the inserts out of a Coventry Die head.
They are very easy to pick up and one will do any thread of that
pitch.
I had some photo's as well but they must be on another hard drive. If
there is any interest I'll either look them out and post them or take
some 'staged' ones to show the setup.
The internal threads can get down to about 3/4 due to physical
constraints but the external has no limit.
You can also do tapered pipe threads by tilting the insert in the
holder.
Steadram does thread milling programs for anybody who needs one.