Re: [CAD_CAM_EDM_DRO] 3/4" dovetail cutter feeds/speeds

Ok group here is what I did opened it up and then
took a old 1" end mill and ground it in to a 1/8 " t
slot cutter and opened it up then used my "NEW" dove
tail and finished it off worked out real good it has
been over twenty years since I cutt a dove tail and
that one I cut with a shaper

John
--- mark watts <markwatts66@...> wrote:

> On mild steel try 350RPM and 3 in. per minute feed
> rate. I take it you're
> opening the slot with an 1/2" end mill/slot drill
> before going in with the
> dovetail cutter because going straight in with the
> dovetail cutter will more
> than likely smash it whatever the speed/feed.
>

_________________________________________________________________________

> Get Your Private, Free E-mail from MSN Hotmail at
> http://www.hotmail.com
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an
> unmoderated list for the discussion of shop built
> systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe:
> CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe:
> CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@...
> Moderator: jmelson@...
> timg@... [Moderator]
> URL to this page:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>

__________________________________________________
Do You Yahoo!?
Get email at your own domain with Yahoo! Mail.
http://personal.mail.yahoo.com/