Re: [CAD_CAM_EDM_DRO] Best ball screw prices? (was: Ball screw load ratings)
Posted by
Jon Elson
on 2001-03-07 14:03:17 UTC
Jeff Swayze wrote:
from Thompson for these screws. They will tend to whip when spinning at
less than 1000 RPM, I suspect, for even relatively short lengths of 18" or
so. They will really bow when loaded to 500 - 1000 Lbs linear force
in compression. I'm using .895" ballscrews on my small Bridgeport
mill, and they are bowing a bit, I think.
Jon
> Well, after further review I agree completely. I've decided to buy5/16" ?? That's awfully small. Take a look at the maximum speed charts
> the Thomson Saginaw 5/16" .200 lead ballscrew and the preloaded ball
> nuts.
from Thompson for these screws. They will tend to whip when spinning at
less than 1000 RPM, I suspect, for even relatively short lengths of 18" or
so. They will really bow when loaded to 500 - 1000 Lbs linear force
in compression. I'm using .895" ballscrews on my small Bridgeport
mill, and they are bowing a bit, I think.
> Does anyone have a source whose price is significantly (5%+) lessSupposedly, HiWin has the best prices, or at least, very competitive.
> than Thomson's? All I found so far is Reid Tool, and they're a few
> cents cheaper.
Jon
Discussion Thread
Jon Elson
2001-03-07 14:03:17 UTC
Re: [CAD_CAM_EDM_DRO] Best ball screw prices? (was: Ball screw load ratings)
Doug Harrison
2001-03-07 15:58:05 UTC
Re: [CAD_CAM_EDM_DRO] Best ball screw prices? (was: Ball screw load ratings)
Jeff Swayze
2001-03-07 17:05:11 UTC
Re: Best ball screw prices? (was: Ball screw load ratings)
JanRwl@A...
2001-03-07 17:21:14 UTC
Re: [CAD_CAM_EDM_DRO] Best ball screw prices? (was: Ball screw load ratings)
Carlos Guillermo
2001-03-07 18:26:56 UTC
RE: [CAD_CAM_EDM_DRO] Best ball screw prices? (was: Ball screw load ratings)
Tim Goldstein
2001-03-07 18:56:44 UTC
RE: [CAD_CAM_EDM_DRO] Best ball screw prices? (was: Ball screw load ratings)
Les Watts
2001-03-07 18:59:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: Best ball screw prices? (was: Ball screw load ratings)