[CAD_CAM_EDM_DRO] wood sander rebuilding

Hello Woodworkers.
Its serious I need some help on this.
The factory (Danckaert, Belgium) broke and I didn´t get any contact.
Does anybody have an reasonable design for returning the tensioning
drums of this Sander?
Thanks Sven Peter



Hello folks,
are our woodworkers able to help me on?

One of my elder clients asks me to rebuild his cannibalized
industrial wood sander. It is not a toy, weights about 3 to 4 tons,
has a transport belt on the table, and two sets of sanding drums for
the course and fine sanding with belts.
The sanding motors are 50 hp (37 KW) each (seems I'm little out aged: SI
versus. imperial)
The endless sandpaper is 1,32 m wide and 2,5 m long.
The working drums are about 300 mm diameter and little more than 1,40 m
long.
The pivoting drums for tensioning and positioning are diameter 175 mm
and 1,38m long. They have their pivot close to the middle of the drum.
where the tensioning cylinder is.
The electrical plan is unavailable and many parts are missing but that
is not so bad. (My daily bread)

What I need is:
First: How is the appropriate barrel form of the tensioning drums?
One is completely worn and the other some genius turned it straight!
I guess at the moment that I need in the centre 2 mm more diameter than
on the ends and the form is a radius.

Second: What to go with for the valve of the positioning cylinder
that swivels the tensioning drum? A valve with 5 way and 3 positions
with closed centre that makes more sense to me
or a 5 way 2 position valve as the actual?

Third: What is an appropriate oscillating rate of the positioning
cylinder.
I have seen other machines oscillating perhaps tipping the air sensor
every 5 or 10 seconds.
And the supervisor tells me the cylinder bounces faster than 3 Hz.


Good Luck to all
Sven Peter

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager

FAQ: http://www.ktmarketing.com/faq.html

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/