dremel alternatives
Posted by
Peter Chen
on 2001-03-12 21:25:28 UTC
Good afternoon everyone,
Re:Dremel alternatives:
If the bearing on the actual Dremel tool is not up to
the job, how about Dremel's flexible shaft? One could
perhaps fabricate a jig to hold the tip of the
flexible shaft. Perhaps the bearing of the flexible
shaft is better? With the shaft tip connected to the
z-axis of a gantry aka super-tech or techno-isel, etc.
the other end of the shaft connected to the Dremel
proper dangling above the gantry. Would this be an
improvement compared with using the Dremel tool
direct?
Peter
____________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.co.uk
or your free @... address at http://mail.yahoo.ie
Re:Dremel alternatives:
If the bearing on the actual Dremel tool is not up to
the job, how about Dremel's flexible shaft? One could
perhaps fabricate a jig to hold the tip of the
flexible shaft. Perhaps the bearing of the flexible
shaft is better? With the shaft tip connected to the
z-axis of a gantry aka super-tech or techno-isel, etc.
the other end of the shaft connected to the Dremel
proper dangling above the gantry. Would this be an
improvement compared with using the Dremel tool
direct?
Peter
____________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.co.uk
or your free @... address at http://mail.yahoo.ie
Discussion Thread
Peter Chen
2001-03-12 21:25:28 UTC
dremel alternatives
Tim Goldstein
2001-03-12 21:44:59 UTC
RE: [CAD_CAM_EDM_DRO] dremel alternatives