Re: [CAD_CAM_EDM_DRO] oversized bearing balls for ball nuts
Posted by
ptengin@a...
on 2001-03-17 12:24:37 UTC
Joel,
I still think at best you would need balls .002 inch oversize as the balls are on "both sides" of the screw. Hence my thinking that .147 would not even fit.....
Peter
In a message dated Fri, 16 Mar 2001 2:00:46 PM Eastern Standard Time, "Joel Jacobs" <jj@...> writes:
<< I asked the 'chief engineer' at Nook about the relationship between ball
size and backlash and he says it's "approximately 1 to 1 with this screw".
I have enough room for two nuts on my x axis but there just isn't room on
the y axis. The one nut I have is less that 1 thou backlash, I may just use
that on the y and get another nut and put two on the x. (If I can't get the
oversized balls)
Joel
I still think at best you would need balls .002 inch oversize as the balls are on "both sides" of the screw. Hence my thinking that .147 would not even fit.....
Peter
In a message dated Fri, 16 Mar 2001 2:00:46 PM Eastern Standard Time, "Joel Jacobs" <jj@...> writes:
<< I asked the 'chief engineer' at Nook about the relationship between ball
size and backlash and he says it's "approximately 1 to 1 with this screw".
I have enough room for two nuts on my x axis but there just isn't room on
the y axis. The one nut I have is less that 1 thou backlash, I may just use
that on the y and get another nut and put two on the x. (If I can't get the
oversized balls)
Joel
Discussion Thread
Joel Jacobs
2001-03-16 08:13:41 UTC
oversized bearing balls for ball nuts
dave engvall
2001-03-16 10:33:22 UTC
Re: [CAD_CAM_EDM_DRO] oversized bearing balls for ball nuts
ptengin@a...
2001-03-16 10:36:30 UTC
Re: [CAD_CAM_EDM_DRO] oversized bearing balls for ball nuts
Joel Jacobs
2001-03-16 10:48:56 UTC
Re: [CAD_CAM_EDM_DRO] oversized bearing balls for ball nuts
wanliker@a...
2001-03-16 11:30:54 UTC
Re: [CAD_CAM_EDM_DRO] oversized bearing balls for ball nuts
Smoke
2001-03-16 15:43:18 UTC
Re: [CAD_CAM_EDM_DRO] oversized bearing balls for ball nuts
ptengin@a...
2001-03-17 12:24:37 UTC
Re: [CAD_CAM_EDM_DRO] oversized bearing balls for ball nuts