CAD CAM EDM DRO - Yahoo Group Archive

RE: Stepper Power Supply

Posted by John Ross
on 1999-08-13 14:23:24 UTC
Ok I've as close as I have to a 15000UF 50V cap is 25000UF at 40V. Is that
close enough?

John R.
-----Original Message-----
From: John Ross [mailto:johnr@...]
Sent: Friday, August 13, 1999 12:23 PM
To: 'CAD_CAM'
Subject: [CAD_CAM_EDM_DRO] Stepper Power Supply


From: John Ross <johnr@...>

Hey looking through my junk I've found a 110v -> 24v 5amp transformer and a
25amp 50 VPIV rectifier. Anyone know if these will work with the Camtronics
5amp kit?

JR





--------------------------- ONElist Sponsor ----------------------------

ONElist members are using Shared Files in great ways!
http://www.onelist.com
Are you? If not, see our homepage for details.

------------------------------------------------------------------------
Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
bill,
List Manager

Discussion Thread

John Ross 1999-08-13 11:23:01 UTC Stepper Power Supply WAnliker@x... 1999-08-13 11:51:33 UTC Re: Stepper Power Supply Robert Bachman 1999-08-13 16:12:02 UTC Re: Stepper Power Supply Dan Mauch 1999-08-13 13:32:41 UTC Re: Stepper Power Supply John Ross 1999-08-13 14:12:05 UTC RE: Stepper Power Supply John Ross 1999-08-13 14:23:24 UTC RE: Stepper Power Supply Dan Mauch 1999-08-13 16:00:20 UTC Re: Stepper Power Supply Bertho Boman 1999-08-13 16:14:35 UTC Re: Stepper Power Supply Bertho Boman 1999-08-13 21:47:34 UTC Re: Stepper Power Supply