Re: [CAD_CAM_EDM_DRO] Post processing of G - code
Posted by
Bob Campbell
on 2001-03-20 06:46:41 UTC
Bob,
One suggestion would be to write a basic program to carefully rearrange the
order of the code. Make sure that you are not in modal mode.
Bob Campbell
One suggestion would be to write a basic program to carefully rearrange the
order of the code. Make sure that you are not in modal mode.
Bob Campbell
----- Original Message -----
From: <bwhite@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, March 19, 2001 8:00 PM
Subject: [CAD_CAM_EDM_DRO] Post processing of G - code
> Is there software in the low cost form that I as a hobbist can use to
> process the G-code prior to machining/engraving?
>
> I have figured out how to create a dxf file and then use the MaxNc
> mill program to create the G-code. The problem I see now is the
> milling machine is doing the cuts in the order they were initially
> drawn, ie. jumping around. For a small file, selecting the
> lines/curves in the order I want them machined is fine. I have have
> large graphics that I would like to engrave and they would be very
> time consuming to select every line individually.
>
> Thanks,
> Bob
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
Discussion Thread
bwhite@s...
2001-03-19 18:01:01 UTC
Post processing of G - code
Bob Campbell
2001-03-20 06:46:41 UTC
Re: [CAD_CAM_EDM_DRO] Post processing of G - code