CAD CAM EDM DRO - Yahoo Group Archive

Re: Another Power Supply Question

Posted by Bob Bachman
on 1999-08-19 07:54:14 UTC
Jon,

Thanks for the info. We'll give it a try.

Bob

At 11:52 PM 8/18/99 -0500, you wrote:
>From: Jon Elson <jmelson@...>
>
>
>
>Bob Bachman wrote:
>
>> From: Bob Bachman <bobach@...>
>>
>> I want to use a pc power supply for a project. Some pc power supplies
>> won't run unless hooked to a motherboard? I know there is a 'power
>> made good' connection which feeds back from the mbd to the ps.
>> How do I make the ps think it's connected to a mbd?
>
>No, the power OK is a signal from the PS to the motherboard that
>it is OK to start operation. Mostly, these power supplies need a load
>on at least the +5 and +12 outputs. If the load is too small, the voltage
>will surge past the desired voltage and cause the overvoltage crowbar
>to trip. You will probably need to draw a few amps at +5V and at
>least a half or one amp at +12V.
>
>Jon
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
>ONElist members, don't miss out on the latest news at ONElist!
>Join our community member news update
><a href=" http://www.onelist.com/subscribe/onelist_announce "here</A>
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the
discussion of shop built systems in the above catagories.
>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>

Discussion Thread

Bob Bachman 1999-08-18 21:26:50 UTC Another Power Supply Question Jon Elson 1999-08-18 21:52:02 UTC Re: Another Power Supply Question Bob Bachman 1999-08-19 07:54:14 UTC Re: Another Power Supply Question