Re: Digest Number 137

I would use a PIC cpu with a basic interpreter in it or a basic compiler.
Lots of advertisers out there in Nuts and Volts.

Check out :http://www.parallaxinc.com/company/.

Paul
-----Original Message-----
From: mllmdupr@... <mllmdupr@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Friday, August 20, 1999 2:30 PM
Subject: Re: [CAD_CAM_EDM_DRO] Digest Number 137

>From: mllmdupr@...
>
>in regards to dan's prior statement refering to his lack of
>knowledge in PIC assembly, the september issue of Electronics Now
>has an article on that very subject utilizing a PIC16F84
>microprocessor in its tutorial. This issue may leave the newstands
>shortly,
> Mel D.
>
>--------------------------- ONElist Sponsor ----------------------------
>
>You can WIN $100 to Amazon.com by starting a new list at ONElist.
>Drawing is held each week through August 20. For details, go to
>http://www.onelist.com/info/onereachsplash3.html
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager