Re: [CAD_CAM_EDM_DRO] Black box?

Gentlemen,

At a glance, it looks like DeskNC downloads motion control info to a pulse
generator which then sends it out to drivers at a smooth rate. I am just
guessing.

Sounds like a smart approach.

Tom E.

----- Original Message -----
From: Tim Goldstein <timg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, April 18, 2001 11:42 AM
Subject: RE: [CAD_CAM_EDM_DRO] Black box?


>
> The signal generator (black box) is sold by Carken (Authors of the
> software). If you go to the site http://www.deskam.com and e-mail them
> asking for the price of DeskNC Windows you will get the cost and be told
> that it includes the black box.
>
> Don't feel I should post the price as Carl is not publishing it on the
site
> at the present, but I will say that it is pretty close in cost to CNC Pro
> full version (which I just noticed has increased in price again).
>
> Tim
> [Denver, CO]
>
> > I'm using desknc for dos and i'm very please with,but the lack g
> > codes support is leading me to get the desknc for windows.
> > there is only one problem,where do I get the signal generator?Or so
> > called black box?
> > Anybody could point me in the right direction>?
> > Thank's
> > fogassa.
> >
> > FAQ: http://www.ktmarketing.com/faq.html
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>