emc to microkinetcis controls
Posted by
davidpontes@m...
on 2001-05-04 19:13:30 UTC
I just came back from the NAMES show, I am new to the cnc club. I saw MICROKINITCES CONTROLS on the hexapod mill,need cable pin out from the PC to micro's rackdrive, so I can run EMC. Looked at mamual, I don't get the picture- what is up or down. I am just a cnc machinest not a eletronics tec. I would like to send information to someone who coule make a 25 pin m-f cable. I have SERVO PRODUCTS mini mill which I intend to use EMC on with the rack drive and a rotary table from sherline products. As is Micro's program is quite out date, in fact FANUC T6 control old as they are would run circles around MICRO'S programing.
EMC seams to be the better way to go!
david pontes
davodpontes@...
[Non-text portions of this message have been removed]
EMC seams to be the better way to go!
david pontes
davodpontes@...
[Non-text portions of this message have been removed]