Re: [CAD_CAM_EDM_DRO] Thoughts on PC Based Control Retrofit....Po wer Supply, advice?

For what its worth ???:

The new Brigar electronics fllyer lists a 2 KVA toroidal power transformer 120 V (240 ?) input 86volt secondary center
tapped-- 20 amps. item #159226 $59.95.

http://brigarelectronics.com

Jesse

Tim Goldstein wrote:

> I would prefer to have a 100V or so cap. It is just so smelly and loud when
> one of those big caps blows it's guts.
>
> Tim
> [Denver, CO]
>
> > -----Original Message-----
> >
> > Ok, I have found some 44VCT 11A transformers for my series I
> > retrofit. Coupled with a 35A 1000V Bridge Rectifier and a
> > 14000MFD 75V Capacitor for each motor, do you folks think this
> > should be a good power supply? By my calculations, I should have
> > about 62VDC.
> >
> > Thoughts guys?
> >
> > Marty
> >
> > FAQ: http://www.ktmarketing.com/faq.html
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/