RE: [CAD_CAM_EDM_DRO] BOSS Rapids Clarification-WAS BRIDGETTE

Dan,

I did try some circular moves last night but was using a significantly
higher feed rate (F60). No resonance problems noted. I have adjusted the
Gecko using the trim pot as per instructions. I will try it at a lower feed
rate and verify that moving slowly through the speed range doesn't cause any
problems.

Tim
[Denver, CO]

> -----Original Message-----
>
> Tim. Try this even though you don't have the both axes
> connected. Give it a
> circular command like G02x1y1i2 F9and observe the connected motor for
> resonance problems. The purpose of the test is to see if you
> will run into
> very much stepper motor resonance. Then adjust the xn factor
> on the geckos
> to eliminate the resonance if any.
> Dan
>
> FAQ: http://www.ktmarketing.com/faq.html