Re: [CAD_CAM_EDM_DRO] BOSS Rapids Clarification-WAS BRIDGETTE
Posted by
Dan Mauch
on 2001-05-09 08:16:36 UTC
Tim. Try this even though you don't have the both axes connected. Give it a
circular command like G02x1y1i2 F9and observe the connected motor for
resonance problems. The purpose of the test is to see if you will run into
very much stepper motor resonance. Then adjust the xn factor on the geckos
to eliminate the resonance if any.
Dan
circular command like G02x1y1i2 F9and observe the connected motor for
resonance problems. The purpose of the test is to see if you will run into
very much stepper motor resonance. Then adjust the xn factor on the geckos
to eliminate the resonance if any.
Dan
Discussion Thread
Joe Vicars
2001-05-09 06:16:51 UTC
BOSS Rapids Clarification-WAS BRIDGETTE
Tim Goldstein
2001-05-09 07:26:11 UTC
RE: [CAD_CAM_EDM_DRO] BOSS Rapids Clarification-WAS BRIDGETTE
Dan Mauch
2001-05-09 08:16:36 UTC
Re: [CAD_CAM_EDM_DRO] BOSS Rapids Clarification-WAS BRIDGETTE
Tim Goldstein
2001-05-09 09:11:27 UTC
RE: [CAD_CAM_EDM_DRO] BOSS Rapids Clarification-WAS BRIDGETTE