Re: [CAD_CAM_EDM_DRO] Bridgeport CNC to Geckos and AC Tech variable speed drive
Posted by
Joe Vicars
on 2001-05-11 11:01:27 UTC
Gary, you can still use the speed control, it is manual. The original control did not control spindle speed.
I have mine hooked up real easy. with a separate 24V supply.
But if you are going to put on a VFD and have spindle speed output (0-10V) from the control then it does make sense to just set the
manual control and leave it. You still have the back gear for really high torque needs.
garyswindell@... wrote:
I have mine hooked up real easy. with a separate 24V supply.
But if you are going to put on a VFD and have spindle speed output (0-10V) from the control then it does make sense to just set the
manual control and leave it. You still have the back gear for really high torque needs.
garyswindell@... wrote:
> I recently aquired a Bridgeport Series I CNC (rigid ram) with a BOSS
> 5 controller (controller is dead). In addition to replacing the
> controller with Gecko Drives I am going to replace the mechanical
> variable speed drive system with an electronic one.
>
> It would seem the proper procedure is to simply lock the "variable"
> part of the system into the highest RPM setting and then let the
> electronics take over from there. What is the best way to lock the
> speed this way? Of course I can't use the air motor on the speed
> controller because the controller is dead.
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Discussion Thread
Joe Vicars
2001-05-11 11:01:27 UTC
Re: [CAD_CAM_EDM_DRO] Bridgeport CNC to Geckos and AC Tech variable speed drive