PCB Mill (Was Re: small stuff (list goals/aims/results?))

> 1) What is this 'dermal' you mention?

should be dremel
http://www.dremel.com/Europe.html

> 2) How good is the repeatability of your machine? (One of the

reasons
ive put a scan of the circuit in the files pic section BIPPOLER.jpg
this is one of the first using one of the Dremel engraving bits i
have since made a bit which dose a beter job but all the boards or in
use and boxed up I will scan a new one the next time i do one. Proper
mechanical eching bits would be better ive got some on order I will
let you know how i get on.

> I've not gotten very far on the machine is that I worry that the
> resulting machine might not be accurate enough for making simple
> printed circuit boards.
>
> Thanks!
>
> --marco